Symptoms
- Error code related to fill time or water supply appears
- Fill step takes unusually long before erroring out
- Machine may attempt to fill multiple times before showing the code
- Problem coincides with low household water pressure
Likely causes
- CommonLow water pressure or partially closed supply valveIf water enters too slowly, the machine assumes a fault and stops with an error rather than waiting indefinitely.
- CommonClogged inlet screensDebris in the small screens where hoses connect can restrict flow enough to trigger the error.
- CommonKinked supply hoseA bent or pinched hose slows fill enough to cause a timeout error.
- PossibleFailing water inlet valveA weak or partially failed valve can let some water through, just not enough or fast enough.
What to do
- Check that both water supply valves are fully open, not just cracked.
- Inspect and straighten any kinks in the supply hoses.
- Turn off the water, disconnect the hoses, and clean the small inlet screens of any debris.
- Test household water pressure at a nearby faucet to rule out a general low-pressure issue.
- Reconnect everything and run a test cycle to see if the fill completes without erroring.
- If the error persists with confirmed good pressure and clean screens, an appliance technician can test the water inlet valve.
Tools and parts
- Adjustable wrench
- Soft brush
Washing machine water inlet valveSearch: “washing machine water inlet valve”
When to call a pro
If the error persists after confirming good water pressure and clean inlet screens, an appliance technician can test the water inlet valve.
Safety
Generally low risk
Generally low risk for a careful person. Stop if anything looks different from what this guide describes.