Symptoms
- Display shows a letter/number code
- Machine stopped mid-cycle
- Buttons may be unresponsive until the code clears
- Error appeared after a power blip or overload
Likely causes
- CommonWater supply or drainage issueMany common codes relate to water not filling or draining properly, often from a kinked hose or clogged filter.
- CommonDoor/lid not locked or detected as closedA door sensor issue is one of the most frequent codes across brands.
- CommonUnbalanced or overloaded drumThe unit detects an unsafe spin condition and stops with a code rather than risk damage.
- PossibleHeating or sensor fault (for drying codes)A specific drying-related code can point to a heating element or moisture sensor problem.
What to do
- Write down the exact code shown and look it up in your model's manual or the manufacturer's website.
- Power-cycle the unit (unplug for a minute, or use a reset button/sequence if the manual specifies one).
- Check that the door is fully closed and latched, and that water supply valves are open if the code relates to filling.
- Redistribute the load evenly if the code relates to balance or spinning.
- Check and clean the drain filter/pump filter, usually behind a small access panel at the front base, if the code relates to draining.
- Contact the manufacturer's support with the exact code and model number if it persists after these checks.
Tools and parts
- Manual/model number reference
- Towel (for filter access)
When to call a pro
Call an appliance technician if a reset, checking the door/water supply, and cleaning the filter don't clear the code.
Safety
Generally low risk
Generally low risk for a careful person. Stop if anything looks different from what this guide describes.