Sinks & faucets

Pull-down sprayer hose is leaking

Leaks from a pull-down or pull-out kitchen sprayer are usually at the hose connections or a cracked hose, both easy to check under the sink.

Difficulty
Easy
Time
20–40 minutes
DIY cost
$10–$30
Pro cost
$100–$180

Symptoms

  • Water dripping under the sink when the sprayer is used
  • Wet cabinet floor near the base of the faucet
  • Sprayer feels like it's losing pressure
  • Leak only happens when spray mode is active

Likely causes

  • CommonLoose hose connection at the faucet body or spray headQuick-connect fittings can work loose over time.
  • CommonCracked or worn hoseThe flexible hose can crack from years of pulling and retracting.
  • PossibleWorn O-ring at a connection pointSmall rubber seals dry out and fail with age.
  • PossibleFailed diverter valveCan send water to the wrong path and appear as a leak.

What to do

  1. Turn off the water supply under the sink before working on the hose.
  2. Trace the hose from the spray head down to where it connects at the faucet body and check both ends for looseness.
  3. Hand-tighten or use pliers to snug any loose quick-connect fittings.
  4. Turn the water back on and run the sprayer, watching closely along the hose length for the exact leak point.
  5. If the leak is mid-hose, look for cracks or worn spots; a cracked hose should be replaced rather than patched.
  6. If the leak is at a connection, turn off water again and replace the O-ring or washer at that fitting.
  7. Reconnect, restore water, and retest the sprayer at both full pressure and spray mode.

Tools and parts

  • Pliers
  • Adjustable wrench
Pull-down sprayer hoseSearch: “pull down kitchen faucet hose replacement”

When to call a pro

Call a plumber if the leak is inside the faucet body itself or you can't identify the exact source.

Safety

Generally low risk

Generally low risk for a careful person. Stop if anything looks different from what this guide describes.

Related guides

Operator provides AI-generated troubleshooting information. It can be wrong. For safety-critical, electrical, gas, structural, medical, automotive safety, or other high-risk problems, consult a qualified professional.