Symptoms
- Continuous beeping after the cycle ends
- Buzzer sounds even when the dryer isn't running
- Beeping starts randomly during a cycle
- Pressing buttons doesn't silence the alarm
Likely causes
- CommonEnd-of-cycle signal setting left on and being ignored as 'stuck'Some models beep repeatedly at intervals until the door is opened, which can feel like it's stuck.
- PossibleStuck or sticky control buttonA button that doesn't fully release can cause continuous or repeated beeping.
- PossibleControl board glitchElectronic controls can occasionally glitch and need a power reset.
- PossibleDoor left slightly ajarSome models beep intermittently as a reminder if the door isn't fully closed after a cycle.
- Less commonFailed control board or speaker componentA malfunctioning board can get stuck sending a signal to the buzzer continuously.
What to do
- Open and firmly close the dryer door to rule out an ajar-door reminder beep.
- Check the owner's manual for how to adjust or turn off the end-of-cycle signal/buzzer setting.
- Press and release each button on the control panel to check for one that feels stuck or doesn't spring back.
- Unplug the dryer for one minute to reset the control board, then plug it back in.
- Run a short test cycle to see if the beeping recurs after the reset.
- If a specific button seems physically stuck, gently clean around it or note it as the likely cause.
- If beeping continues randomly after a reset and no button is stuck, have the control board inspected by a technician.
Tools and parts
- Owner's manual
When to call a pro
If a power reset doesn't stop random beeping and no button is stuck, an appliance technician can test the control board.
Safety
Generally low risk
Generally low risk for a careful person. Stop if anything looks different from what this guide describes.